Base Customiser

Procedural miniature bases → STL

Shape

Size measured at table level

Magnet holes

Count 0 = auto (more magnets on bigger bases). Holes are always as deep as the magnet, so it sits flush with the table.

Underside supports

A + of ribs, plus support rings on bigger bases (a ring halfway out from about 90mm). Magnets sit where the rings cross the +.

Top texture

Fine enough for resin; an FDM nozzle won't resolve much of it. Printing top-down on a textured bed? Leave this on Smooth and let the bed do the work. Big textured bases take a few seconds and make large STLs.

TGB mark

Table Goes Boom initials inside the underside, placed and sized automatically in the clearest spot. Raised suits printing top-down; engraved suits printing upright.

Nameplate

Sits on the front edge (towards you in the default view). Width 0 fits the plate to the name. For the cleanest prints, export the nameplate on its own: it comes out ready to print (ledge flat, plaque standing up), and its back is cut from the base wall so it glues on flush.

Advanced dimensions
Generating…